What satellite should i point my directv dish at

Before re-peaking your satellite dish, access the Signal Meters menu from the Settings and Help menu on your receiver to use the signal meter to monitor the broadcast signal to your satellite dish. To access the Signal Meters menu:. Re-position your television to be in your line of sight while re-peaking your satellite dish. If possible, have a friend monitor the signal meter and relay the broadcast signal strength to you while you are re-peaking your satellite dish.

The support sleeve nuts are located on the back of your satellite dish. Check that the mast is level. If the broadcast signal strength is lost because of strong wind or other inclement weather, the mast supporting your satellite dish may no longer be level.

If the mast has not moved, you can skip to the next step, which is adjusting the azimuth of your satellite dish. To check if the mast is level:. Adjust the azimuth of your satellite dish. The azimuth refers to the rotation of the whole satellite dish around a vertical axis the mast. It is the horizontal side-to-side angle.

To adjust the azimuth of your satellite dish:. If the broadcast signal strength is still not to desired level, you can also adjust the elevation of your satellite dish. The elevation of your satellite dish should only need adjustment if the elevation bolts have come loose.

The elevation bolts are on either side of the back of your satellite dish. Adjust the elevation of your satellite dish. The elevation refers to the angle between the satellite dish pointing direction, directly towards the satellite, and the local horizontal plane.

It is the vertical up-down angle. To adjust the elevation of your satellite dish:. After you have adjusted the azimuth and adjusted the elevation, confirm all support sleeve nuts and elevation bolts are tightened. Confirm on the signal meter of the Dish Pointing menu that the broadcast signal strength is at its highest level. Content is for informational or entertainment purposes only and does not substitute for personal counsel or professional advice in business, financial, legal, or technical matters.

Mr evaresti kimaro from dsm tz,I'm istoll in mapinga bagamoyo on July 18, I am a 66 year old woman who has had terrible reception on my DTV for quite some time. Today I happened upon your website. I did not have to move my dish at all. Your suggestion that I reset my connection unplug and wait 30 seconds and replug improved my reception imediately.

Next I checked my settings and had it reset per your instructions and now my reception is great. If an old woman like me can handle this anyone can. Thank you so much for your assistance. From the comments I see below many should just call a service technician. I found the article very easy to understand and use but I also have many years in antennas that help me understand it. You may need to loosen the nuts on the support sleeve to adjust the dish.

Go to the on-screen "Dish Pointing" menu. Access the signal meter to verify you are getting a signal from the dish. If not, adjust the azimuth setting until you receive a signal. Listen for a continuous tone from the signal meter. Use the tick marks at the top of the dish mast, and rotate dish to the right one tick mark at a time, pausing for three to five seconds at each mark. Stop when you hear the continuous tone and reach the highest signal on the meter. The maximum strength is If you do not hear the tone, start again, but rotate the dish to the left until the tone is heard.

Tighten the support sleeve nuts when finished. Loosen the elevation nuts on the LNB support arm. Move the dish up one tick mark at a time, pausing for five seconds. Stop when you get the highest signal on the meter. In the UK there is a dominant satellite broadcaster, hence nearly all the dishes tend to point in the same direction — close to southeast. A satellite dish must have a clear line of sight to the satellite. Satellite broadcast channels are called transponders. Each transponder contains up to 20 TV channels.

The minimum signal level for a transponder to provide a clear picture is about Satellite Dish Installations. The National Electric Code requires that all satellite dish systems be grounded. The mast and coax cables both require a ground. This does not mean that the installer can drive a ground rod by the dish, attach a ground wire and call it good.